[[ImgSrc-moreshare]]

Contact Us

Tel: +86-510-88100289

Fax: +86-510-88102325

Mob: +86-15370222672

E-mail: grandy@wxshuhang.com

Add: Xinming Industrial Area, Xibei Town, Xishan District, Wuxi, Jiangsu, China

Home > Exhibition > Content
The safety operation specification of the PP yarn string wound filter cartridge machine Oct 26, 2017

When operating the PP yarn string wound filter cartridge machine, the staff must strictly abide by the corresponding safety operating procedures. Compliance with these requirements is mainly to ensure the correct operation of the PP yarn string wound filter cartridge machine, and safety. So what specific requirements should meet? Come and look at the specific content!

 

The following is the concrete steps for the safety operation procedure of the PP yarn string wound filter cartridge machine:

The first step, before turning on the PP yarn string wound filter cartridge machine, the staff needs to check whether the mold and the strength and accuracy of the mold base meet the requirements, and also to ensure the sharp edge grinding, the installation is firm, and the fastening is reliable. At the same time, the staff also needs to check and confirm that the transmission part of the protective hood is strong. Do not dismantle at will. The second step, before processing, the staff should set the required processing specification parameters, without exceeding the allowable range of machinery.

The third step, after finishing above preparations, the PP yarn string wound filter cartridge machine should run in no-load condition. The production operation should be started after the confirmation is normal. In the production process, the staff should pay attention to maintaining the material speed reasonable and uniform.

 

It should be noted that, in the case of the PP yarn string wound filter cartridge machine without center hole wafer, the corresponding safety measures should be taken in combination with production situation. During the whole operation, other non-operational and auxiliary personnel should not stay around the machine.

 

After the production operation is over, the PP yarn string wound filter cartridge machine should be closed and the total power supply should be cut off according to the requirements. The on-site staff also needs to clean up the offcut around the machine in time, and do the daily maintenance of the machine, and also clean the environment site.

 

WUXI SHUHANG MACHINERY SCIENCE AND TECHNOLOGY CO.,LTD.

Add: Xinming Industrial Area ,Xibei Town,Xishan District,Wuxi,Jiangsu,China

Contact: Ge Beizhi

Tel: +86-510-88100289

Fax: +86-510-88102325

Mob: +86-15061527476

E-mail:grandy@wxshuhang.com

Website:http://www.shuhangmachinery.com